Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Default Security Group is enabled by default to all project servers and includes a few Security Rules which enables access from Servers to external networks and opens ssh connection to Servers.

User can disable Default Security Group to any project server changing Server switch button to off state.User can't create any new Security Rule in Default Security Group.

Server Security Group

Image Removed

Server Security Group includes Security Rules for a selected server.

...

When Server with optional Application is created, TDS Server Security Group is created including all necessary Security Rules for installed Application.

User can enable Server Security Group for another Server - not recommended.

There is a Project quota limit for Security Rules in public TDS - maximum number of Project Security Rules is the same as maximum number of Servers allowed in the Project.

User can save changes or delete Server Security Group using button SAVE respective DELETE.

User can cancel his actions in Security Server Group view pressing button Escape.

...

  • Direction
    • Egress direction means direction from TDS Server to other hosts or networks. By default egress is allowed to all networks and for all protocols and ports.
    • Ingress direction means direction from external hosts or servers to TDS Server. By default ingress is not allowed except to Application protocols and ports installed by TDS.
  • Protocol
    • Possible values:
      • Any
      • TCP
      • UDP
      • ICMP
  • Remote IP
    • Source of the traffic to be allowed via this rule. Expected values should be entered in the form of an IP address block. For all IPs 0.0.0.0/0 can be used.
  • Port from
    • The field means a single port or beginning of the range of ports which will be used for the rule
    • Valid only for TCP and UDP protocols
    • Integer value between 1 and 65535 can be used only
  • Port to
    • The field means a single port or end of the range of ports which will be used for the rule
    • Valid only for TCP and UDP protocols
    • Integer value between 1 and 65535 can be used only
  • Action
    • Action which will be performed for the rule
    • The only action which can be used for the rule is REMOVE
    • After removing of the rule from the view, it's ncessary necessary to press SAVE to write REMOVE action to Server Security Group.

...